Mathematical modeling of zinc concentrate roasting in a fluidized bed

The paper aims to stabilize the roasting of zinc sulfide concentrates in fluidized-bed furnaces using oxygen- enriched air. The balance between the given excess air blast (on average 20%) and the amount of loaded charge is achieved by selecting an appropriate number of evaporative cooling elements in the fluidized-bed furnace. Through the evaluation of scientific and technical information, as well as literature sources on the research topic, data were collected on the effects produced by an oxygen excess in the blast on the quality of sulfide concentrate roasting and by a blast volume on the state of the fluidized bed. In addition, statistical data for the study were obtained by analyzing the operation of fluidized-bed furnaces at Electrozinc. As part of the study, the heat balance in roasting was determined, taking into account the following technical characteristics of fluidized-bed furnaces used for roasting zinc sulfide concentrates: fluidized- bed level, number of nozzles, furnace diameter, diameter in the bed zone, hearth thickness, and the total weight of the furnace. Relying on the operation analysis of fluidized-bed furnaces, a method was proposed to regulate the oxygen supply depending on the amount of loaded charge. The oxygen supply is regulated in order to ensure a stable excess of oxygen in the blast without causing any significant changes in the blast volume and, consequently, to maximize the sulfur removal from the charge. A decrease in the excess air blast below 15% was found to significantly degrade the quality of the resulting cinder and dust, while an increase of over 20% reduced the SO₂ content in the exhaust gases with no noticeable improvement in the quality of cinder. Therefore, the proposed method for regulating the oxygen supply to the furnace can improve the techno-economic performance of zinc sulfide concentrate roasting in fluidized-bed furnaces.

1. Fleissner F., Eberhard P. Load balanced parallel simulation of particle-fluid DEM-SPH systems with moving boundaries. In: Parallel Computing: Architectures, Algorithms and Applications: Proceedings of Conference. 4–7 September 2007, Julich. Julich; 2007, vol. 38, р. 37–44.

2. Alkatsev M. I., Alkatseva V. M. An investigation of the dependence of roasting characteristics of sulfide nickel concentrates in fluidized bed furnaces on various factors by the method of design imitation experiment. Izvestiya Vuzov. Tsvetnaya Metallurgiya = Izvestiya. Non-Ferrous Metallurgy. 2009;3:60-63. (In Russ.).

3. Constantineau J. P., Bouffard S. C., Grace J. R., Richards G. G., Lim C. Jim. Demonstration of the conditions conducive to agglomeration of zinc calcine in fluidized bed roasters. Minerals Engineering. 2011;24(13): 1409-1420. https://doi.org/10.1016/j.mineng.2011.06.002.

4. Chen T. T., Dutrizac J. E. Mineralogical changes occur-ring during the fluid-bed roasting if zinc sulfide concen-trates. JOM. 2004;56(12):46-51. https://doi.org/10. 1007/s11837-004-0235-y.

5. Davies R. H., Dinsdale A. T., Gisby J. A., Robinson J. A. J., Martin S. M. MTDATA – thermodynamic and phase equilibrium software from the national physical laboratory. Calphad. 2002;26(2):229-271. https://doi.org/10.1016/S0364-5916(02)00036-6.

6. Svens K., Kerstiens B., Runkel M. Recent experiences with modern zinc processing technology. Erzmetall. 2003;2:94-103.

7. Rutkovsky A. L., Dyunova D. N., Bigulov A. V., Yako-venko I. S., Bilaonov B. D., Dzantiev S. Sh. Investigation of the roasting process of zinc concentrates in a fluidized bed by mathematical modeling. Mining informational and analytical bulletin (scientific and technical journal). 2013;3:217-222.

8. Gerasimenko N. P., Rutkovskij A. L. Investigation of zinc concentrate roasting in a fluidized bed for the purpose of optimization. In: Nauchno-tekhnicheskaya konferenciya obuchayushchihsya i molodyh uchenyh SKGMI “NTK-2018”: sbornik dokladov po itogam nauchno-issledovatel'skih rabot = Scientific and technical conference of students and young scientists of North Caucasian Mining and Metallurgical Institute "STC-2018": collected reports on the results of scientific research works. 17–25 May 2018, Vladikavkaz. Vladikavkaz: North Caucasian Mining and Metallurgical Institute; 2018, р. 13-17. (In Russ.).

9. Ivakina S. A., Munts V. A. Fluidized bed furnace for roasting zinc concentrates as a control object. Izvestiya Tomskogo politekhnicheskogo universiteta. Inzhiniring georesursov = Bulletin of the Tomsk Polytechnic University. Geo Assets Engineering. 2018;329(9):31-42. (In Russ.). https://doi.org/10.18799/24131830/2018/9/2086.

10. Kubaschewski O., Alcock S. B. Metallurgical thermo-chemistry, 1982. 392 р. (Russ. ed.: Metallurgicheskaya termohimiya. Moscow, Metallurgiya; 1982, 392 р.)

11. Sedov L. I. Methods of similarity and dimension in mechanics. Moscow: Nauka; 1977, 440 р. (In Russ.).

12. Pestunova N. P., Remizov Yu. S., Komkov N. M. On the mechanism of zinc concentrate roasting in fluidized bed furnaces. Kompleksnoe ispol'zovanie mineral'nogo syr'ya = Complex use of mineral resources. 1990;8:55-60. (In Russ.).

13. Panshin A. M., Shakirzyanov R. M., Izbrekht P. A., Zatonskiy A. V. Basic ways of improvement of zinc pro duction at JSC "Chelyabinsk zinc plant". Tsvetnye metally. 2015;5:19-21. (In Russ.). https://doi.org/10.17580/ tsm.2015.05.03.

14. Boateng A. A. Rotary kilns: transport phenomena and transport processes. Amsterdame: Elsevier Science; 2015, 369 p.

15. Orhan G. Leaching and cementation of heavy metals from electric arc furnace dust in alkaline medium. Hydro-metallurgy. 2005;78(3-4):236-245. https://doi.org/10.1016/ j.hydromet.2005.03.002.

16. Krasheninin A. G., Khalezov B. D., Bornovolokov A. S., Ordinartsev D. P. Technology for extracting manganese from vanadium converter slag after leaching vanadium. Metallurgist. 2019;63(5):534-542. https://doi.org/ 10.1134/S0036029520010073.

17. Panshin A. M., Viduetskiy M. G., Kozlov D. A., Ivakin D. A. Using zinc cake flotation in columnar type equipment for increasing of Waelz-process efficiency. Tsvetnye metally. 2015;5:59-64. (In Russ.). https://doi.org/10. 17580/tsm.2015.05.12.

18. Kozlov P. A., Kazanbaev L. A., Zatonskiy V. A., Trav-kin V. F. Extraction-electrolysis processing methods of zinc raw materials. Moscow: Ruda i metally; 2008, 269 р. (In Russ.).

19. Farkhondehkavaki M., Soleimani M., Latifi M., Berruti F., Briens C., McMillan J. Characterization of moisture distribution in a fluidized bed. Measurement. 2014;47(1):150-160. https://doi.org/10.1016/j.measurement.2013.08.063.

20. Molodtsova M. Yu., Dobrydnev S. V. Conditions for obtaining the main zinc carbonates from ammonium carbonate water solutions. Advances in chemistry and chemical technology. 2013;27(7):102-105. (In Russ.).